Last edited by Shaktidal
Saturday, May 16, 2020 | History

2 edition of Initial simulation and control system studies of the MIUS coal-fired turbine experiment found in the catalog.

Initial simulation and control system studies of the MIUS coal-fired turbine experiment

S. J Ball

Initial simulation and control system studies of the MIUS coal-fired turbine experiment

by S. J Ball

  • 270 Want to read
  • 37 Currently reading

Published by Environmental Protection Agency, [Office of Energy Technology], Oak Ridge National Laboratory, for sale by the National Technical Information Service in Oak Ridge, Tenn, Springfield, Va .
Written in English

    Subjects:
  • Modular integrated utility systems,
  • Gas-turbines -- Design and construction,
  • Gas-turbines -- Mathematical models

  • Edition Notes

    StatementS. J. Ball
    SeriesORNL/HUD/MIUS ; 42
    ContributionsOak Ridge National Laboratory
    The Physical Object
    Paginationvii, 53 p. :
    Number of Pages53
    ID Numbers
    Open LibraryOL14881333M

    Design and Simulation of Turbine Design for Improving the Performance of Hydro Electric detailed study of turbines is made and a simple new design of turbine is presented. The presented control schemes are used to regulate the flow of water in order to keep the turbine speed constant. The basic components of a MTG system are the compressor, combustor, turbine, recuperator and high frequency generator with power electronics interfacing [2]. A. Micro-Turbine The simplified single shaft gas turbine including all its control systems which is implemented in MATLAB / SIMULINK is shown in fig. 1 [5, 6]. The model consistsCited by:

    Simulation of Gas Turbine Operations Etebu, O.M.O A generalized non-linear mathematical model for the steady state operation of a gas turbine was developed to study the response modes of pre-specified sensitive parameters of the system. For a realistic understanding of description of steady-state system simulation is thatFile Size: KB. control systems. Computational studies of plasma flow control have been limited in comparison to the vast number of experimental studies reported []. Recently, the authors developed a simple phenomenological numerical simulation methodology for active flow separation control applications using plasma actuators [15].Cited by:

    STEAM TURBINE 1 CONTENT Chapter Description Page I Purpose 2 II Steam Turbine Types 2 Impulse Turbine 2 Reaction Turbine 2 III Steam Turbine Operating Range 2 Curtis 2 Rateau 2 Reaction 4 IV. Symbols and Units 5 V. Steam Process in Steam Turbine 6 Size: KB. In this study, Simulink and NARX models are created and validated using experimental data sets to explore transient behaviour of a heavy-duty industrial power plant gas turbine (IPGT). The results show that both Simulink and NARX models successfully capture dynamics of the by: 7.


Share this book
You might also like
Imperialism, the highest stage of capitalism

Imperialism, the highest stage of capitalism

Real Estate Exam Preparation Guide for California

Real Estate Exam Preparation Guide for California

fit for a king

fit for a king

Minor irrigation development in Bangladesh

Minor irrigation development in Bangladesh

Queer exoticism

Queer exoticism

The London programme

The London programme

Night in Glengyle.

Night in Glengyle.

Success in literature

Success in literature

Radiation control of Salmonellae in food and feed products

Radiation control of Salmonellae in food and feed products

economics and politics of the socialist debacle

economics and politics of the socialist debacle

Assessment of risk in the newborn

Assessment of risk in the newborn

Best of Harley Davidson

Best of Harley Davidson

How fast was velociraptor?

How fast was velociraptor?

The Divine Conquest

The Divine Conquest

Initial simulation and control system studies of the MIUS coal-fired turbine experiment by S. J Ball Download PDF EPUB FB2

The simulations indicate that the present control system design is capable of handling expected load transients satisfactorily.

The dynamic characteristics of the experiment were investigated to determine specific control system designs required to satisfy varying electrical and waste heat demands and, at the same time, to keep plant component temperatures and stresses within acceptable limits.

Get this from a library. Initial simulation and control system studies of the MIUS coal-fired turbine experiment.

[S J Ball; Oak Ridge National Laboratory.]. Abstract. This study identified and determined optimal design and operating conditions that would offer the maximum power plant efficiency of both subcritical and supercritical pulverized coal-fired power plants.

A process-based computer model of the pulverized coal-fired power plants was successfully developed using the principles of coal combustion, combustion chemistry, heat transfer from a Cited by: The Modeling and Simulation of a Microturbine Generation System Godswill Ofualagba Abstract— In a hybrid energy system consisting of renewable sources of energy, there should be some storage facility or backup generation to maintain continuity of supply to the load when renewable source alone is.

Modeling and simulation of the start-up process of coal fired power plants with post-combustion CO 2 capture case study, the existing control system is compared for the simulation and the. Modelling, Simulation and Control of Gas Turbines. Using Artificial Neural Networks.

Hamid Asgari. A thesis presented for partial fulfilment. of the requirements for the degree of. Doctor of Philosophy. Mechanical Engineering.

at the. University of Canterbury. Christchurch, New Zealand. February In its place, small hydropower systems have been increasingly used as an alternative energy source of hydro power.

So a small system is installed in small rivers or streams with little environmental effect. water head turbine is the most generally A used system, and this makes the turbine rotate by converting the potential energy of the water.

A new coordinated control strategy for boiler-turbine system of coal-fired power plant Abstract: This paper presents the new development of the boiler-turbine coordinated control strategy using fuzzy reasoning and autotuning techniques.

The boiler-turbine system is a very complex process that is a multivariable, nonlinear, slowly time-varying Cited by: Most importantly, it can be concluded from the output whether the gas turbine engine is operating in a region of adequate compressor and turbine efficiency.

Matching technique proposed in the current work used to develop a computer simulation program, which can be served as a valuable tool for investigating the performance of the gas turbine at off-design by: This paper studies the application of nanocoated material in design and development of turbine engine blade using computational simulation and prototype testing to investigate the performance Author: Jeremy Li.

GAS TURBINE WITH THERMAL/EROSION PROTECTIVE COATINGS A full-scale gas turbine for study of dynamically applied Fuel Volume 75 Number 5 Coal-fired gas turbine and ash separation system." A.

Povitsky and Y. Goldman 11 Figure 11 Particle concentration in cyclone B. Vertical longitudinal section, between jets; horizontal longitudinal section, jet by: 2. control systems work. This work was conducted within the ITEA3 project MODRIO, which has the aim to "extend state-of-the-art modelling and simulation environments based on open standards to increase energy and transportation systems safety, dependability and performance throughout their.

Modelling and Simulation Approaches for Gas Turbine System Optimization: /ch This chapter deals with research activities that have been carried out so far in the field of modelling and simulation of gas turbines for system optimizationCited by: 1.

both hydraulic and electrical system components. It uses a conventional turbine model developed by authors from the Institute of Electrical & Electronics Engineers (IEEE) [10].

The current study is specifically concerned with the hydraulic modelling aspects of the Francis type reaction turbine incorporated in the PSS/E Size: KB. ventional boiler-turbine coordinated control system (CCS), steam temperature control system, combus-tioncontrolsystem,andfeedwatercontrolsystem,in which the respective thermal dynamic variables are controlledseparately.

Boiler-Turbine Coordinated Control System Current plant or unit control strategies allow gener. The simulation was implemented in the power system simulation tools in MatLab SIMULINK. The output curves of the Simulink model (currents, power and voltages) and the actual measurement at the same wind speed taken from the actual operation of the kW wind turbine installed at UMass-Lowell are in good by:   Hey guys.

This is just the science project I did, it's a model of a steam turbine that I made from scratch and my own ides.

(p.s. I only got a 95 on it when people who did the entire project and. Gas Turbines Modeling, Simulation, and Control: Using Artificial Neural Networks not only offers a comprehensive review of the state of the art of gas turbine modeling and intelligent techniques, but also demonstrates how artificial intelligence can be used to solve complicated industrial problems, specifically in the area of by: 8.

MATLAB /Simulink for the dynamic simulation of a gas turbine power generation system. The model has been implemented as a stand alone application, but its main purpose is to be included in a more complex model that integrates the gas turbine load, the accessories and the control system for Software in the Loop or Hardware in the LoopFile Size: KB.

of this simulation model. The developed gas turbine model is validated for the design, off-design and transient cases with available data from the literatures.

Following the validation, the gas turbine model is applied to a cross-disciplinary co-simulation by: 2. Computer Simulation of a Gas Turbine Performance By D. P. S Abam, N. N. Moses University of Port harcourt, Nigeria. Abstract- The current research is aimed at carrying out an exergy analysis of a MW gas turbine power plant that operates on the Brayton cycle.

Quantitative exergy analysis for each component and for the whole system was Size: KB.1) mode transition from the low speed propulsion system to the high speed propulsion system, 2) high Mach turbine engine development, 3) transonic aero-propulsion performance, 4) low-Mach-number dual-mode scramjet operation, 5) innovative 3-D flowpath concepts and 6) innovative turbine based combined cycle integration.CONTROL SYSTEMS, ROBOTICS AND AUTOMATION - Vol.

XVIII - Gas Turbines - Hans-Kaspar Scherrer, Christopher Ganz and Wolfgang Weisenstein ©Encyclopedia of Life Support Systems (EOLSS) Hence, the power plant can be started up and even operated with the gas turbine only.